Mobile-Net

How To Better Using Your Car Battery

How to better using your car battery

Simple steps and through the illustrations you can take care of your car Laptop Battery. Maintain it in Good Condition as long as possible and avoid to replace a new battery.

1 - cleaning cables (connectors)

Cleans the surface of the Inspiron 1521 Battery up and take note of any corrosion on the heads and clips (a tablespoon of soda (bicarbonate), then dissolved a cup of warm water and non-metallic brush to rubbe the cleared sediment and then pours cold water to remove these sediment and the bicarbonates.

But before you disconnect the cable, be sure that do not lose the programming may be used in some devices of car attachement such as radio programming, radio stations. You can use this simple link (shown below the image) to ensure the electrical power supply suitable for the memory of those devices during the battery separation period. 9 volts is enough to temporary keep the memory of radio electric and would be sufficient for a period of a hour.

Now it is possible that ...

Separating the cables and start the negative cable to prevent accidental short-circuit (Short Circuit to car body), using the header key measure Drill 5 / 16 in Box Wrench or any other nut install a link cable, and then clean the grate and brushing link Bgha Almgamsp solution of bicarbonates can also soak the cup containing the link to the bicarbonates to get rid of acid deposition on lattice and calcifying link.

2 - open manhole covers of battery

And check the level of the acid solution within the view of the battery through the holes, where the level must be the solution about 1 / 2 Ang lead-up sheet inside the Dell Inspiron 1720 Battery , in the case of the low level of this strengthens the addition of distilled water to raise the level of liquid to 1 / 2 Ang required, and attention should be not to add a lot of distilled water causing rash solution outside of the battery.

Should be left for the distilled water to mix with the solution in the meantime, check and inspect the body of the battery from the cracks or broken as in this case requires replacement of the battery with new ones.

After it is better to re-connect cables to the so as not to lose the programming of peripheral devices.

3 - Checking the battery charge

Density of the solution should be checked using a test known as Almkthav Hydrometer the battery is fully charged when the readings in all the holes is 1.265 or higher, and if the reads 1.200 or less, it means that the battery had lost its shipped and must be re-shipped (and this test and reading mean specific gravity the solution).

4 - Lifting and replace the battery

For the purpose of raising the battery must be open and the separation of cables and start racing as we must disconnect the negative cable first and then the positive cable and you should not use force or violence when the disassembly in order not to get damage to link emerging from within the battery Terminal As shown in the picture below.

For the purpose of raising the battery must care and caution, especially that were not equipped Bmmsk and the holder of the special battery heavy and may fall, causing spills acid solution and the destruction of the dye and a metal car, or may cause damage to the engine that landed by mistake.

5 - Installing the new battery

Must also be done carefully and install the battery cables and make sure that the end of the cable clamps related to negative or positive non-worn or Mthrcp diameter and is suitable for Qatar as a connector on the battery is important to note that the diagonal of the node positive and negative points is equal and this means that the lattices related Eabelin positive and negative as well as with different Qtarhama terms.

When installing the clip preferably Chhimh very light layer of petroleum jelly material to prevent corrosion.

And then re-install the battery holder and installed into place to ensure that the specified movement.

6 - Use of sealed batteries, Sealed No Maintenance Batteries modern that do not require maintenance

Containing the battery was appointed to monitor the status of the battery . When careful consideration by the index was green, it means that the battery is good, loaded, and the scene was a dark (black) means that the battery needed for shipping and that was the color yellow or colorless, the battery is worn out and must be replaced, and here must be examined carefully and with a lamp detector to make sure.

This type of battery does not need to maintain and add distilled water to examine the density and quality of the solution, but know the condition of the battery and the validity of the eye examination, as explained nose.

Is very appropriate for our country because of the high ambient temperature, which usually cause an increase in evaporation of water from a solution of in summer and cause dryness and damage to the battery, especially when the loss of follow-up and ongoing monitoring of how many batteries does a lot of drivers of vehicles.

About the Author

Focus on write review and introduce of laptop battery, electronics and digital produce.

JAVOedge Jelly Case

« Previous1234Next »